Colt Walker 1847
An 1847 Colt Walker cased with all accessories: a bullet mold
with a bullet and spur attached; nipple wrench and screwdriver;
a
cap box with six caps inside; four bullets; and, a powder
flask with a removable base in the flask partition for
the makers
label ... as was described in an article on the original
gun.
Mr Talbot
loves to add such historical detail to his work.
Display Cases
The cases
are custom made by Mr Talbot to suit each pistol and its
accessories. The same careful selection of timber, fittings
and attention to fine workmanship is given to them. Brazilian
mahogany, supplied by Otto Timbers in Magill, South Australia,
is used. Slotted brass screws are difficult to find these
days, but Mr Talbot found a source in Western Australia.
The locks and keys for the cases are from a specialist supplier
in Tasmania. All the tooling is done by hand to suit each
job.
